 |
 |
 |
|
|
|
[Sponsors] | ||||
"interior" face definition in CFX |
Welcome, bestucan.
You last visited: September 8, 2022 at 11:06 Private Messages: Unread 0, Total 2.
|
![Reply](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="110" height="26"><rect fill-opacity="0"/></svg> "Reply") |
|
|
LinkBack
![](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="11" height="7"><rect fill-opacity="0"/></svg>)
|
Thread Tools
|
Search this Thread
|
Rate Thread
|
Display Modes
|
![Old](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="10" height="11"><rect fill-opacity="0"/></svg> "Old")
September 12, 2007, 18:19
|
![Default](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="16" height="16"><rect fill-opacity="0"/></svg> "Default")
"interior" face definition in CFX
|
#1 |
|
Guest
Posts: n/a
|
how do i define a face in CFX which is usually defined as "Interior" in FLUENT??
|
|
![Report Post](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="21" height="17"><rect fill-opacity="0"/></svg> "Report Post")
|
![Reply With Quote](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="70" height="22"><rect fill-opacity="0"/></svg> "Reply With Quote")
![Multi-Quote This Message](data:image/svg+xml,<svg xmlns="http://www.w3.org/2000/svg" width="25" height="22"><rect fill-opacity="0"/></svg> "Multi-Quote This Message")
|
|
|
September 12, 2007, 21:13
|
Re: "interior" face definition in CFX
|
#2 |
|
Guest
Posts: n/a
|
If the mesh region exists, just apply a wall to the region and select the option "Create Thin Surface Partner", which will create a corresponding wall on the other side of the thin surface. Note that Pre will have already split a single interior region into two primitive regions when the mesh was imported.
-CycLone |
|
|
|
|
|
|
| Tags |
| None |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ATTENTION! Reliability problems in CFX 5.7 | Joseph | CFX | 14 | April 21, 2010 03:45 |
| Different flow pattern between OpenFOAM and CFX | AirS | OpenFOAM | 0 | January 12, 2010 19:08 |
| CFX doesn't continue calculation... | mactech001 | CFX | 6 | November 16, 2009 09:25 |
| heat generation in CFX | Ema | CFX | 4 | August 7, 2009 17:39 |
| Electronics Enclosure Analysis with CFX | Simulation Engineer | CFX | 1 | April 22, 2009 23:08 |
